Multi-Storey Rubber Roof Installation
Not only did this project require two roof installations, but the higher storey also required the incorporation of an angled hip roof and chimney.
Two large rubber flat roof extensions were applied on two separate storeys, both adhered using a water-based adhesive and supported through contact adhesive around the perimeter. The roof was installed as a single large sheet incorporating the chimney and hip roof details. RubberCover flashing tapes were used to waterproof these unique roofing details.
Whilst installing this Coverings for Flat Roofs, the QuickTrim roof edge details was applied, with QuickTrim Check Kerb and Drip Edge details utilised for a clean finish.
